The Cause Behind The Cause

One of the most important skills in radionics is finding “the cause behind the cause  “, or in other words getting to the “bottom line” of what is the cause of a problem. If you or your subject were suffering from reoccurring headaches, for example, you could find a rate for a headache in a rate book such as the Kelly Rate Book available free HERE, balance out the headache, and in a short time hopefully  the headache will be gone, but unless you find the “cause behind the cause”,  the headaches will more than likely keep returning, especially if the subject has been suffering from chronic headache problems. The same holds true for any condition. Finding “the cause behind the cause” has been compared to “peeling an onion”

onion

The first step is to identify the Major Condition in the subject. To use an example, we’ll say that your subject is having digestion problems. So you decide to first check the stomach. Look up the rate for the stomach in the rate directory, the rate for the stomach is 77-84.

Put 77-84 on the top bank of your radionic instrument ( this is best done with a two-bank radionic instrument, I suppose you could also do it with a single bank instrument by writing the rate 77-84 on a piece of paper and putting it in the well with a witness of your subject, then mentally dowsing for answers to what the problems with the stomach are.) As I was saying put the rate for the stomach  (77-84) on the top bank  Check the intensity of the rate for the stomach next to General Vitality (9-49), if there is a problem within the stomach it probably won’t have an intensity reading as high as G.V., it might be a lot lower. If the intensity is as high as G.V. that’s an indication that the problem could be in another part of the digestive system, check other parts of the digestive system using the above procedure. In this case, we’ll say the General Vitality of the stomach was 650 compared to 800 for G.V, so the stomach is strongly suspected of being the source of the problem.

Put the rate for the stomach ( 77-84) on bank 1.  Now you’ll have to do a bit of cold scanning. Mentally ask ” What is the number 1, major problem with the subject’s stomach” while slowly turning the left-hand dial on bank 2, then slowly turning the right-hand dial on bank 2, until you get a “stick”  for each, then stop, write the numbers down. Now check the intensity you got for the rate you just scanned. You may get more than one rate, go with the one with the highest intensity for now. You can use the intensity dial to dowse for “How many problems are there with the subject’s stomach” you can also use the same procedure to find out how many causes there are.

We will say you got a rate of 40-32, which is inflammation of the stomach. Leave that rate on bank 2, zero the dials on bank 1 ,next you would mentally ask “What is the major cause behind this problem” while slowly turning the dials on bank 1, suppose you got a rate of 92-85 which is ulcers, leave that rate on bank 1 , and use bank 2 to dowse the question” What is the cause behind the cause on bank  1″, say you get 24.5-32 which is excess acidity.

You can now dowse using the intensity dial for a yes/no answer while asking the question” Are there any more causes behind the rate on the bank?  If yescontinue using the above procedure until you have found all of the causes. If the answer was no, you have two choices, you can balance the condition in the subject using the rates you have found, your list could be as short as a couple of rates, or more than a dozen. If you want to be really thorough, and you have the time ( although it’s not really necessary) you can put each rate that you found on one bank of your radionic instrument one at a time, and dowse the question ” What is this causing”. As an example, the rate that you got of 24.5-32 excess acidity could be causing other problems in the body.

list for cause behind cause

Whenever you get a  rate you can dowse using the intensity dial of your instrument or a pendulum these questions.

  • Does this rate correspond to a living organism? YES/NOFirst cause
  • Does this rate correspond to a condition? Such as hypo/hyper tonicity? Degregation? Acidity?/Alkalinity? High/Low temperature? Electrical pollution?
  • Does this rate correspond to a chemical toxin? Agricultural? Food Additive? Atmospheric? Environmental?
  • Does this number correspond to a heavy metal? A food allergy?

The great thing about radionics is that you can really find the cause behind the cause behind the cause, behind the cause etc. depending on how extensive you want to be, and how much time you have. When cold-scanning you don’t need a name for the rate that you’ve found, it’s nice to put a name to the rate, but it’s not necessary.

 

 

 

Fine-tuning a radionic instrument

One of the most valuable skills that you can learn in radionics is the art of fine-tuning a radionic instrument. For example, if you wanted to broadcast to someone to balance a certain condition say  Insomnia. First, you would look up a rate for Insomnia ( there are more than one) and you decided to use the rate 53-91. First go through the “preparatory protocols” now  set the dials on your radionic instrument for 53-91, and with a witness of the subject having problems sleeping in the well of your instrument, broadcast this rate to them for the time you determined by dowsing and in time it would probably have some effect on the subject.

On the other hand, if you wanted the rate to be much more effective, and work a lot quicker you would first fine-tune it.

The rates listed in a standard radionic rate book are “rough” rates, they will work, but they will work much better if fine-tuned specifically for the subject you are trying to help.

To fine tune a rate you would first need to find a rate for the condition in the person, plant, animal, etc. that you wish to help. This can be done in one of three ways. One way is to look up the rate in a radionic rate book or directory, another way is to cold-scan the rate, and last but not least you could set-scan the rate. The first way is pretty obvious, you can download a rate book with thousands of rates from Kelly Radionic Technologies free of charge. The second way of cold-scanning takes a bit more work. Cold-scanning is used when you don’t know what the condition is that’s affecting the subject and /or you don’t have a rate book to use.

To cold-scan you would put the subjects witness ( photo, blood spot, hair clipping etc.) in the well.   Turn the Left-hand dial to 0 and the Right-hand dial to 100. If you have no idea of what the subject’s problem is you could mentally ask the question, while slowly turning the left-hand dial on your radionic instrument ( Left-hand dial is the condition dial, Right-hand dial is location dial) and rubbing the stick plate and  focusing your thoughts on something like ” What is the major #1 condition affecting the subject”? When you get a “stick” stop, check the number the dial pointer is on and write it down. Now while slowly turning the Right-hand dial and rubbing the stick plate mentally ask ” What is the major location for the condition indicated on the Left-hand dial”, again stop when you get a stick and write down the number. Now check the intensity of the rate you just found, we’ll say it’s 350, write that down too.

If you know either the location of a condition, but not the condition or the condition but not the location you can “set-scan” to find the unknown half of the rate. For example, we’ll say your subject has “Strep” the rate for that condition is 60-. With the subject’s witness in the well, put 60- on the Left-hand dial, while slowly turning the right-hand dial and rubbing the stick plate. stop when you get a stick, write down the numbers and check intensity.

We will use the first example to explain how to “fine-tune” a rate. The condition in the first example was “Insomnia” which is 53-91. Make sure the witness for the subject is in the well, put the rate of 53-91 on your instrument ( 53 on the left-hand dial and 91 on the right-hand dial). Now check the intensity of this rate in that particular subject, say for example it’s 350. To fine-tune this rate, turn the left-hand dial very slightly, stop and check the intensity, turn it a bit more and check the intensity again, keep doing this until you get the highest intensity reading. Now do exactly the same thing for the right-hand dial until you get the highest intensity reading (you may have to move the dial pointer forward and backward to find the highest intensities)  Stop when both dial is set to the highest intensities. ( Most radionic instruments are marked in graduations of “01”mattioda instrument If you were fine-tuning the rate 53- try 52.50, 52.75, 53.00, 53.25, 53.50, and so on… and check for intensity each time you move the dial pointer.) You will notice that when your rate is fine-tuned the intensity for it is much higher than before it was fine-tuned, which is a good thing. Write down the numbers. You are now ready to “broadcast” this “fine-tuned” rate to the subject once you determine the broadcast time and you check for appropriateness.

P.S. The above examples are for a Hieronymus style radionic instrument, I’m sure there are ways to fine-tune other types of radionic instruments, but I’m only familiar with fine-tuning Hieronymus type instruments.

Getting a “stick”on a radionic machine

Some people when beginning to use radionic equipment equipped with a “stick” plate, have a problem getting a reaction or stick. Other people get a reaction right from the start, others ( a small percentage) can never seem to get a stick or any reaction.

First of all, I will explain what a stick is. When using a radionic instrument you have to ask a lot of questions mentally, for example, “What is the rate for the subject’s major problem” or ” Is it appropriate to broadcast this rate to the subject” or any questions that you may need to have answers to. The only way to determine what the answers are by some type of reaction, in this case getting a stick on the stick plate. Some radionic practitioners use a pendulum instead of a stick plate, some radionic instruments do not have a stick plate and are meant to be used with a pendulum. The small percentage of people who never can learn to use a stick plate can sometimes use to use a pendulum instead.

A “stick” is like the stick plate has suddenly become”sticky” when you have the answer, and your hand “sticks” to the stick or reaction plate, another way to describe a stick is like your hand is made of metal and the stick plate becomes magnetized when you have the answer to your question.

Getting a stick when using a radionics instrument is similar to finding water underground using dowsing rods or a forked stick. What you are doing is communicating with the Universal Sub-Conscious mind, there is nothing weird or spooky about this, it isn’t witchcraft of occult. Everyone has contacted Universal mind at one time or another. You think of a person, and within a few minutes the person calls you, or you get an intuition to take a different road than you usually take, and find out later that the road was blocked at that time because of an accident, or maybe you get a “hunch” to buy a lottery ticket, and you win money. You didn’t know these things intellectually, but you tapped into the Universal mind which has the answers to every question. This is how you get answers when using a radionic instrument.

 

kelly-analyzer-04
The “stick” plate is the black square item in the above photo of this Kelly Personel Instrument

When you are using a radionic instruments stick plate, rub the plate in a clockwise or counter-clockwise motion, which ever way is most comfortable,  with your finger tips touching the stick plate. Just don’t rub the stick side to side because it is much more difficult to get a stick, because you stop twice, so it’s much more difficult to recognize a stick.

If you are having a bit of difficulty getting a stick try rubbing your hand together. Some people with sweaty hands put a bit of cornstarch on their finger tips. Some people find if they pass a quartz crystal across their hands they will be able to get a stick easier. If you have difficulty in getting a stick the first few times using a radionics instrument..PRACTICE…PRACTICE…PRACTICE. If you only spend 10 or 15 minutes a day practicing you will “get it”.

Another “tip”, once you are able to get a stick and you are asking a question mentally or you are scanning for an intensity of a rate, when you get the stick write the answer down and move on, don’t go back and ask the same question again, and again because you think that the first time or second time you got the “wrong answer”. You want to train the mind to quickly zero in on the correct answer. Another bonus of using radionics is that the more you use radionics the better your mind will be able to focus, not just for radionics, but in every area of life.